COMMENT
CAB INTERIOR: Tidy. The drivers seat cushion is in good condition - backrest has several large seam splits. The passenger seat cushion also has some seam splits - backrest okay. Dash, parcel tray and glove compartment presentable - one knob missing from the heater controls and a hole where a stereo has been removed. Roof lining complete but has a couple of small holes and several grubby marks. Overhead console and centre rise console presentable. Rear wall lining also intact but very grubby. The R/H door lining is torn along the bottom and the plastic trim surrounding the latch is broken. L/H door lining okay but covered in grubby tar marks. Drivers side floor mat is completely worn out - remaining floor mats intact but dirty. CAB EXTERIOR: Tidy - no significant rust or damage. There are a couple of shallow dents in both front wheel guards and small patch of rust blistering under the paint at the bottom of the drivers door. Paintwork generally in good condition - some stone chips on the front panel and mudguards. BODY: Fitted with a 3900mm long Flocon body. The interior and exterior cladding on the vee bin is in good repair - some residue tar inside but no obvious wear or damage. There is a 650mm wide slat conveyor at the bottom and the bottom tray is heated by the truck's exhaust. Hydraulics are PTO powered. There is a tar spray gun and pump mounted at the L/H rear corner along with a hose reel retractor. Also included with the truck are a hydraulic powered concrete cutter and small breaker. There are tool boxes built in to the sides of the body and there is a long shallow dent in the R/H side. A side discharge chute is included with the truck but was not available at the time of inspection. MECHANICAL: Engine grubby - the L/H side of the block is wet with oil which looks to be coming from the rocker cover gasket. There is a further minor oil leak at the compressor output shaft seal. Cold started instantly with a minor amount of white smoke emission initially - cleared quickly and ran smoothly with clean emission warm at revs and at idle.
TYRES
9.00R20. Front - 40% remaining tread both sides. Rear - L/H 20 & 30% remaining tread, R/H 50%.